There are common, everyday sources of ethylene that can be picked up on by the sensors in your Felix Gas Analyzers. Common sources of ethylene include smoke or exhaust. Furthermore, the ethylene sensors inside of the Felix Gas Analyzers are also sensitive to various volatile organic compounds (VOCs). Various cleaning agents are often a source of VOC readings. If you are inside, it is not uncommon for the ethylene sensors to report readings between 0-0.5ppm of ethylene. If you are outside, drawing clean ambient air (away from traffic, smoke, or other sources of exhaust) it is more typical to see 0.0 ppm readings for ethylene.
The 16GB card provided with the F-9xx gas analyzers technically has indefinite storage capacity as the files can be moved off the card to reopen storage space. However, without moving any files off the card, it can hold up to ~60 million measurements from a F-9xx analyzer. If the instrument is saving data every minute that equates to ~40,000 days of measurement before the SD card is full.
I don’t feel that my F-9xx Gas Analyzer is reading accurately, what should I do?
When communicating with support it is helpful to provide:
If your analyzer is less than three months old, see the two options below:
Perform a set zero calibration on the sensors using the external conditioning chamber filled with potassium permanganate for the ethylene sensor and the external conditioning chamber filled with soda lime for the CO2 sensor. Use the O2 calibration in air menu option to calibrate the O2 sensor using ambient air. Only use the O2 set zero setting if you are using 100% nitrogen gas.
Please see the user manual for more details.
If your analyzer is over three months old, see options below:
If your instrument is over three months of age, inaccurate sensor readings could indicate a need for calibration. You can try a baseline calibration (or set zero) of the sensors first and if this does not bring the readings into spec, then perform a full calibration.
Please see ‘How Do I Calibrate the Instrument?’ FAQ for more details.
The sensors within your gas analyzer are calibrated with a two-point calibration, with verification at a third point using certified standard gases. These three points include: 1. A set zero or baseline calibration for the sensor; 2. a span or gain calibration of the sensor; and 3. verification with a third standard gas concentration between the baseline and gain points.
The sensor response will naturally drift over time. To make sure you are getting accurate readings it is essential that you keep up with the calibration schedule of the instrument.
Set zero or baseline calibration
The set zero calibration should be completed once a week. The gas analyzers are supplied with external conditioning chambers and the proper solids to perform this process. No standard gases are required for this, please see your corresponding user manual for more details.
Span or gain calibration
A span calibration should always be preceded by setting the baseline response of the sensor. If performing a span calibration, please review the ‘How do I calibrate the instrument?’ FAQ.
What standard gases do I need to calibrate my instrument on my own?
Note: Due to limitations of Microsoft Translate, manuals greater than 50 pages in length currently do not support dynamic translation.